WindFall iPad POS Stand Setup

The WindFall Stand is a great way to display your iPad register for everyday usage. There are a few different versions: for iPad 4, for iPad Air/iPad Air 2, and for iPad Mini 2/3/4. Are you already set up but running into issues? Check out our Troubleshooting Guide for solutions to common problems!

Check out our WindFall iPad POS Stand Setup video below:

WindFall Stand Setup

Table of Contents

iPad 4 and iPad Air/Air 2 Setup

Follow along below to set up the WindFall stand for iPad 4 or the Windfall for the iPad Air/iPad Air 2.

After setup, visit our best practices guide to learn how to care for the stand.

Included with the iPad Stand

The WindFall iPad Stand ships with all of the parts and pieces shown below:

Click to Enlarge

Secure the iPad to Stand

Before using the PivotTable or stand feet, install your iPad in the stand itself.

  1. Use the assembly key to loosen the screws and remove the backplate.
  2. Place the iPad in the backplate.
  3. Hold the backplate against the stand and reinsert + tighten the assembly screws.

    If using the iDynamo card reader, connect it to the iPad before completing this step.

Installing an iPad Air 2? Insert the fit adapters between iPad and frame for a snug fit.

PivotTable Rotation Base

Set up your stand with the PivotTable to swivel the register around for customers to sign and tip on screen.

  1. Affix an adhesive disk to the bottom of the PivotTable.

    Use the permanent disk to adhere the stand to a counter for good. Otherwise, use the temporary disk.

  2. Set the stand on top of the PivotTable.
  3. Place the cap on top, insert the assembly screw through the ClickSafe anchor, and tighten the screw.

Stationary Setup for iPad

The included plastic feet help protect your stand and countertop. Only install these if you do not want to use the PivotTable.

  • The grey sliding feet allow the WindFall to move freely.
  • The clear friction feet prevent the iPad from sliding around on a countertop.
    1. Set the stand face down.
    2. Remove the backing from the chosen set of feet.
    3. Apply the feet directly to each of the four corners.

    iPad Mini Setup

    Follow along below to set up the WindFall stand for iPad Mini. This stand is compatible with a few versions of the iPad Mini: iPad Mini 2, 3, and 4.

    After setup, visit our best practices guide to learn how to care for the stand.

    Included with the iPad Mini Stand

    The WindFall iPad Mini Stand ships with all of the parts and pieces shown below:

    Click to Enlarge

    Secure the iPad Mini to Stand

    First, install your iPad in the stand. If your stand shipped with a backplate instead of brackets, setup will be similar to the photos above.

    1. Loosen the screws and remove the brackets.
    2. With the stand face down, position the iPad and place the brackets on top.

      If using the iDynamo card reader, connect it to the iPad first.

    3. Hold the iPad with brackets against the stand and secure it with the screws.

      Fully secure one bracket first; it will hold the iPad in place while you do the other.

    Stationary Setup for iPad Mini

    The included plastic feet help protect your stand and countertop.

  • The grey sliding feet allow the WindFall to move freely.
  • The clear friction feet prevent the iPad from sliding around.
    1. Set the stand face down.
    2. Remove the backing from the chosen set of feet.
    3. Apply the feet directly to each of the four corners

    Do you have more questions? Check out our FAQ!